Troubleshooting
4.22 Output Overcurrent Detection
L5
Error Code
An output overcurrent is detected by checking the current that flows in the inverter DC section.
Method of Error
Detection
A position signal error occurs while the compressor is running.
Error Decision
A rotation speed error occurs while the compressor is running.
Conditions
An output overcurrent signal is fed from the output overcurrent detection circuit to the
If the error repeats, the system is shut down.
Reset condition: Continuous run for about 11 minutes without any other error
Poor installation condition
Supposed
Closed stop valve
Causes
Defective power module
Wrong internal wiring
Abnormal power supply voltage
Defective outdoor unit PCB
Power supply voltage is not as specified.
Defective compressor
77
microcomputer.
SiBE041525F
Service Diagnosis