Figure 6 Installing An 8-Port Gigabit Ethernet Adapter Card On A 7705 Sar-18; Connector And Led Descriptions - Alcatel-Lucent 7705 Installation Manual

Installation Procedures
Step 6. Tighten the captive screws to secure the card or filler plate. Do not over-tighten.
Step 7. If you replaced the adapter card, check the Power LED on the adapter card
32
a. To insert an adapter card, see
installation of an 8-port Gigabit Ethernet Adapter card on the 7705 SAR-18
chassis; this procedure also applies to the 8-port Ethernet Adapter card.
Figure 6: Installing an 8-port Gigabit Ethernet Adapter Card on a 7705 SAR-18
XMDA 1 XMDA 2
1 2
XMDA XMDA
i. With the ejector levers rotated inward, hold the adapter card by the levers,
align the card with the slot guides, and slide the adapter card into the slot.
ii. Press the adapter card firmly into the slot by pushing in both ejector levers
at the same time with your thumbs. Make sure that the card connectors are
seated in the backplane connectors and the faceplate is flush with the front
of the chassis.
b. To insert a filler plate:
i. Align the filler plate with the slot and slide it into the slot. Filler plates do
not have backplane connectors.
The recommended torque is 3 to 4 lbf-in (0.34 to 0.45 N
faceplate. If the adapter card is properly inserted and the 7705 SAR-18 has valid
power, the Power LED is lit blue. Refer to
more information on the LEDs.
7705 SAR Ethernet/Gigabit Ethernet Adapter Card Installation Guide
Figure 6
3 1 2
7705 SAR-18
XMDA 3 XMDA 4 CSM A CSM B MDA 1 MDA 2 MDA 3
4
4
1 2 3
Alarms
Fan Critical ACO
Batt A Major
Batt B Minor
BITS1
External
Alarms
BITS2
Alarm
A B Module
3 4
XMDA XMDA
CSM CSM
3 1
and Table 4. Figure 6
MDA 4 MDA 5 MDA 6 MDA 7 MDA 8 MDA 9 MDA 10 MDA 11 MDA 12
4 5 6 7 8 9 10 11 12
0 l
Batt A
0 l
Batt B 0 l
2
.
m).

Connector and LED Descriptions

shows the
22128
for