Figure 5 Removing An 8-Port Gigabit Ethernet Adapter Card From A 7705 Sar-18 - Alcatel-Lucent 7705 Installation Manual

Step 5. Insert the adapter card or filler plate in the empty slot.
7705 SAR Ethernet/Gigabit Ethernet Adapter Card Installation Guide
Figure 5: Removing an 8-port Gigabit Ethernet Adapter Card from a 7705 SAR-18
XMDA 1
1
XMDA XMDA
i. Simultaneously rotate the ejector levers outward to release the adapter card
connectors from the backplane receptacles.
ii. Grip the adapter card by the ejector levers and slide the card out of the slot.
Place the adapter card on an anti-static surface.
iii. If you are not replacing the adapter card immediately, cover the adapter
card slot with a filler plate.
b. To remove a filler plate, pull it out of the slot.
Note:
• Do not attempt to use the captive screws instead of the ejector levers to insert the
adapter card into the slot; the screws are only used to secure the card in place.
• If the adapter card does not seat properly in the backplane, an ejector lever may not be
completely rotated inward. Pull the card out half way, adjust the levers, and reinsert the
card by pushing in both ejector levers at the same time with your thumbs.
3 1
7705 SAR-18
XMDA 2 XMDA 3 XMDA 4 CSM A CSM B MDA 1 MDA 2
4
4
1 2
Fan Critical
Batt A Major
Batt B Minor
BITS1
External
Alarms
BITS2
2 3 4 A B
XMDA XMDA
CSM CSM
3 1
Installing Adapter Cards
2
MDA 3 MDA 4 MDA 5 MDA 6 MDA 7 MDA 8 MDA 9 MDA 10 MDA 11
3 4 5 6 7 8 9 10 11
Alarms
0 l
ACO
Batt A
0 l
Batt B
0 l
Alarm
Module
2
MDA 12
12
22127
31