Setting Pulse Output Conditions - YOKOGAWA PR300 User Manual

3.6 Setting Pulse Output Conditions

This section explains how to set pulse output conditions by taking as an example the case when the ON
pulse width is changed from the initial value to 100 ms.
Operation Operation
Measured Value screen
VT Ratio screen
Pulse Output Menu screen
Measurement
Item for Pulse Output screen
Pulse Unit screen
3-10
1
Hold down
least 3 seconds.
The parameter (VT ratio)
appears.
Using or
2
show
3
Press once.
The parameter
(measurement item for pulse
output) appears.
4
Press once.
The parameter
(pulse unit) appears.
5
Press once.
For the PR300 with pulse output function only
ON Pulse Width screen
for at
ON Pulse Width Setting screen
,
.
ON Pulse Width Setting
screen
ON Pulse Width Setting
screen
ON Pulse Width screen
The parameter
(ON pulse width) appears.
Current value
6
Press once.
The screen changes to the one
for setting the parameter
and the alterable digit blinks.
Setpoint
7
Using or
change the setpoint.
To move to the digit to be changed,
use the following keys:
To the left To the right
8
Press once to
blink the setpoint.
To re-set the parameter:
Press any key other than
while all digits of the
setpoint are blinking.
The PR300 returns to the initial
setting screen.
9
Press once while
the setpoint is blinking.
The setpoint is confirmed and the PR300
returns to the ON Pulse Width screen.
ON pulse width setting completed.
To return to the Pulse Output Menu
screen, press .
To return to the Measured Value
screen, hold down
If you do not operate any key for more
than 5 minutes on the Parameter
screen, the PR300 automatically
returns to the Measured Value screen.
IM 77C01E01-01E
,
.