Alarm Outputs; Disabling Alarm From Device - Level Sense Pro User Manual

7.0 Alarm Outputs

Alarm outputs are set up based on each sensor input. By default,
all sensors have all alarm outputs enabled. If the sensor input is
enabled, it can have alarm outputs. You can disable inputs and
outputs to suit your application and to match your installation
configuration. The Alarm LED will turn red when there is an alarm
and blue when there are no alarms.
7.1 Audible Alarm
Enable the audible alarm for an audible warning. The audible alarm
can be temporarily silenced by pressing the User button.
7.2 Message Alarm
Enable the message alarm to receive alerts to your smart device via
SMS and/or email. Use the test function within Portal to confirm each
recipient. If using email and you do not receive the message, check
your spam folder. You might need to configure spam settings to
allow emails from: alarm@level-sense.com.
7.3 Relay Alarm
Enable the relay alarm to have the dry contact relay change states
on alarm event. The relay is a latching type and will maintain its state
even when the power fails and after the battery has drained. The
alarm relay is useful when connecting the Level Sense Pro into a home
security system. Both NO and NC contacts are available for increased
wiring applications.
7.4

Disabling Alarm from Device

Alarms can be temporarily disabled by pressing the User button on
the Level Sense Pro control. This is particularly useful to silence the
audible alarm once you are aware of the alarm. This will disable the
alarm until it has been cleared and then reoccurs. As an example,
if you silence a temperature alarm, it will not alarm again until
temperature goes back into the non-alarm range, and then returns
into alarm range. If multiple alarms are disabled, all alarm inputs
must be cleared before it will alarm again.
14
(Text/Email)