Connect With Wps - Level Sense Pro User Manual

4.1

Connect with WPS

To connect to Wi-Fi with WPS, first check to see your Wi-Fi router
has a button labeled "WPS." If your router does not, proceed to
connecting with hotspot mode. Temporarily move the Level Sense
Pro control unit into close proximity of the Wi-Fi router. The Level
Sense Pro will operate on battery backup to complete this step if
allowed to charge for 30 minutes prior. Once the two devices are
near each other, press the WPS button on your router first.
Within 15 seconds, double click the USER button on the Level
Sense Pro. The Cloud LED will turn from pulsing white to solid
yellow. The WPS process can take up to three minutes. Upon
successful connection, all four LEDs will illuminate and pulse.
Please note the colors from left to right as they are used later in
the claim process, section 5.2. You have successfully connected
to your home Wi-Fi, please move on to Product Registration.
If the Cloud LED turns red following a WPS attempt, press the reset
TIP:
button to restart the device. If the Cloud LED returns to red after restarting,
check your router settings to see if WPS is enabled. Alternatively, try
connecting with hotspot mode.
10