Kenwood DDX4018DAB Instruction Manual page 37

Settings Settings
<Supreme>*2
Restores the sound lost due to audio compression to a
realistic sound.
• OFF/ON (Initial)
<Realizer>
Virtually makes the sound more realistic using the
Digital Signal Processor (DSP) system. Select the sound
level.
• OFF (Initial)/Level 1/Level 2/Level 3
<Stage EQ>
Moves the center of the sound to the lower or higher
point. Select the height.
• OFF (Initial)/Low/Middle/High
*1 You cannot change the setting when "Radio" or "DAB" (only for
DDX4018DAB) is selected as the source.
*2 This function works only when "DISC"/ "USB"/ "iPod"/
"Android™" is selected as the source.
<Fader/Balance>
Touch [ J ]/[ K ]/[ H ]/[ I ] or drag the
<Fader>
Adjusts the front and rear speaker output balance.
When using a two-speaker system, set the fader to the
center (0).
• F15 to R15 (Initial: 0)
<Balance>
Adjusts the left and right speaker output balance.
• L15 to R15 (Initial: 0)
To clear the adjustment: Touch [Center].
<Speaker/X'over>
Before making any settings for the speakers and
crossover frequency, select the appropriate crossover
network mode according to the speaker system (2-way
speaker system or 3-way speaker system).
• Connecting 3-way speakers with 2-way crossover
network mode selected may damage the speakers.
Crossover network mode settings
1
Display the source/option selection screen.
On the Home screen, touch as follows:
2
Put the unit in standby.
On the source/option selection screen, touch as
follows:
mark to adjust.
3
Press and MENU on the monitor panel
M
at the same time to display the <X'over
Network> screen.
4
Select the crossover network mode.
[2way]
[3way]
A confirmation message appears. Touch [Yes] to
confirm.
Select this when connecting speakers
in a 2-way system (front/rear).
Select this when connecting speakers
in a 3-way system (tweeter/mid
range/woofer).
Setting the speakers and crossover
frequency
1
Select a car type ( 1 ), select the location
of the speakers ( 2 ), then display the
<Speaker Select> screen (
• Speaker location selection is available only when
<X'over Network> is set to [2way].
2
Select the speaker type ( 1
of the selected speaker ( 2
the <X'over> screen ( 3 ).
• If a speaker is not connected, select <None>.
• When setting the front speakers, also select the
speaker size for <Tweeter>.
3 ).
), select the size
), then display
ENGLISH 33