Bluetooth Mobile Phone - Kenwood DDX4018DAB Instruction Manual

Bluetooth® Bluetooth®
2
Select the device ( 1 ) you want to connect,
then select [Connection] (
3
Select the device ( 1 ) to connect, then
return to the <Paired Device List> (
Select [ON] (to connect) or [OFF] (to disconnect).
: Mobile phone
: Audio device
4
Connect the selected device.
28 ENGLISH
• The status is shown as follows:
– <Connecting>: Connection is in progress.
2 ).
– <Connected>: A connection has been established.
– <Connect Ready>: A connection can be
established.
– <Disconnecting>: Disconnection is in progress.
– <Disconnected>: No connection is established.
• When a Bluetooth mobile phone is connected, the
signal strength and battery level are displayed when
the information is acquired from the device.
To delete the registered device: Perform step 1,
select the device you want to delete in step 2, then
2 ).
touch [Remove].
• A confirmation message appears. Touch [Yes].

Bluetooth mobile phone

When a call comes in...
Touching the operation keys performs the following
actions:
[ ]
[ ]
• Call information is displayed if acquired.
• Phone operation is not available while the picture
from the rear view camera is displayed.
Answers a call.
Rejects a call.
• When receiving a call during navigation guidance
(only for DDX4018DAB/DDX4018BT), the screen is
switched automatically.
– To return to the navigation screen, touch [
During a call...
Touching the operation keys performs the following
actions:
Ends a call.
[ ]
Switches between handsfree mode and
[ ]/
phone mode.
[ ]
[DTMF] Enters DTMF (Dual Tone Multi
Frequency), then sends text using the
keypad.
NR LEVEL Adjusts the noise reduction level.
[–] / [+] (–5 to 5, initial 0)
EC LEVEL Adjusts the echo volume level.
[–] / [+] (–5 to 5, initial 0)
MIC LEVEL Adjusts the volume level of the
[–] / [+] microphone. (–10 to 10, initial –4)
• Press + / – buttons on the monitor panel to adjust
the volume of the call or earpiece.
].