Resetting The Accumulated Battery Use Time Indication; Setting The Rf Output Power Level - Sony WRT-8P Operating Instructions Manual

Pressing the + button cycles the
indications in the order shown in the
tables in the pdf files "Sony Wireless
Microphone System Frequency List"
supplied with this Operating
Instructions.
Pressing the – button cycles the
indications in the opposite direction.
Hold down the + or – button to change
the channel number (or frequency)
faster.
4
Set the POWER switch to OFF to
complete the setting, or press the SET
button to set other items.
The results are stored in memory. The
change becomes effective the next time you
turn on the transmitter by setting the
POWER switch to ON, and the transmitter
enters transmit mode with the selected
transmission channel.
Resetting the accumulated
battery use time indication
The accumulated battery use time is the
total time (in hours and minutes) that the
battery has been used. It is recorded
whenever the transmitter is on.
Reset the indication to "00:00" whenever
you replace the battery.
1
Set the transmitter to the setting mode.
2
Press the SET button repeatedly until
the accumulated time indication
appears.
10 Settings
3
Press the – button.
The time indication resets to "00:00."
While "00:00" is still displayed,
previous value can be resumed by
pressing the + button.
4
Set the POWER switch to OFF to
complete the setting, or press the SET
button to set other items.
The results are stored in memory. The
change becomes effective the next time you
turn on the transmitter by setting the
POWER switch to ON.
Setting the RF output
power level
You can select the RF output power level
from "H" (250 mW) or "L" (50 mW) in
setting mode.
1
Set the transmitter to the setting mode.
2
Press the SET button repeatedly until
the RF output power indication
appears.
Current RF
output power
setting
3
Press the + button to select "H" (250
mW), or press the – button to select
"L" (50 mW).
4
Set the POWER switch to OFF to
complete the setting, or press the SET
button to set other items.
The results are stored in memory. The
change becomes effective the next time you
turn on the transmitter by setting the
POWER switch to ON, and the transmitter