Mercury 2 & Intuitive Mobile Controller User Guide
Inputs
Input resistance:
Input type
Comms:
Switched Resistor Example Wiring
Example of resistor fitted on a probe input.
Installation
Panel Cut-out and Clearances
Mercury Mk2 (Flush mount controller)
Dimensions
Mercury Mk2
Warning
Ensure that all power is
switched off before
installing or maintaining
this product
Please Note
3.01K Ohms (for PTC or NTC type probes)
Selectable. See:
Units
RS232 with flow control
Connect to remote switch or relay
Probe Ground
Probe Signal
Fixing
The controller is fixed by sliding the 2 plastic retaining
clips up to rear of the panel. These clips have a ratchet
action and can be removed by holding in the clip sides
and sliding back.
There is no requirement for forced cooling ventilation
Revision 1.1
www.resourcedm.com
Page 19 of 21