Product Summary - Polycom INTERMEC 2100 Configuration Manual

Introduction

Product Summary

Manufacturer:
Approved product(s):
RF technology:
AP software version:
SpectraLink handset models:
SpectraLink radio mode:
Maximum telephone calls per AP:
AP configuration parameters:
Indoor range (typical):
Required network topology:
Network constraints:
WEP capability:
ESSID auto-learn function:
Earlier and later software versions have not been tested for the SpectraLink 8000 SVP Server
†
compliance, except as noted. Refer to Polycom WLAN Compatibility Table for Field Verified AP software
versions.
* Telephone calls per AP must be configured in the system per documentation provided by Polycom.
WEP and Automatic Learn are programmed into each handset in addition to being configured in the AP.
SpectraLink 8000 Wireless Telephones
PN: 1725-36053-001_G.doc
Intermec: MobileLAN Access Points 2100, 2101, 2102, WA21, WA22
This document details the specifications for configuring the Intermec
2100, 2101, 2102, WA21 and WA22 Access Points (APs) with
SpectraLink 8000 Wireless Telephones.
Intermec
2100, 2101, 2102, WA21, WA22
Direct-sequence spread spectrum (DS), 2.4 GHz
†
1.91
e340/h340/i640
802.11b
See Access Point Configuration below.
See vendor specifications for AP.
Switched Ethernet
Dedicated segment for wireless, single subnet
Yes *
Yes *
SpectraLink 8000 Wireless Telephones use voice over IP (VoIP)
technology on IEEE 802.11b-compatible wireless local area networks
(WLANs). Access points utilize radio frequencies to transmit signals
to and from the SpectraLink 8000 Wireless Telephones.
12 *
8020/8030
802.11b
12 *
3