Setting Guidelines - ABB REC670 Applications Manual

Section 19
Ethernet-based communication
19.3.2
19.4
19.4.1
19.4.2
534
IEC17000044 V1 EN-US
Figure 221: Merging unit

Setting guidelines

For information on the merging unit setting guidelines, see section
61850-9-2LE communication
Routes
Application
Setting up a route enables communication to a device that is located in another
subnetwork. Routing is used when the destination device is not in the same
subnetwork as the default gateway.
The route specifies that when a package is sent to the destination device it should
be sent through the selected router. If no route is specified the source device will
not find the destination device.
Setting guidelines
Routes are configured using the Ethernet configuration tool in PCM600.
Operation for the route can be set to On/Off by checking and unchecking the
check-box in the operation column.
Gateway specifies the address of the gateway.
Destination specifies the destination.
Destination subnet mask specifies the subnetwork mask of the destination.
IEC17000044-1-en.vsdx
protocol.
1MRK 511 401-UEN A
GUID-3449AB24-8C9D-4D9A-BD46-5DDF59A0F8E3 v1
IEC/UCA
GUID-19616AC4-0FFD-4FF4-9198-5E33938E5ABD v1
GUID-2C4A312A-00DC-44C8-B2D9-CD0822E1C806 v1
Bay control REC670 2.2 IEC
Application manual