Protocol Reporting Via Ieee 1344 And C37.118 Pmureport - ABB REC670 Applications Manual

1MRK 511 401-UEN A
6.2
6.2.1
6.2.2
Bay control REC670 2.2 IEC
Application manual
In case of multicast IP, it will be the network switches and routers that take care of
replicating the packet to reach multiple receivers. Multicast mechanism uses
network infrastructure efficiently by requiring the IED to send a packet only once,
even if it needs to be delivered to a large number of receivers.
If there are more than one UDP client group defined as multicast, the user shall set
different multicast IP addresses for each UDP group.
The PMU clients receiving the UDP frames can also connect to the IED to request
(command frame) config frame 1, config frame 2, config frame 3, or header frame,
and to disable/enable real time data. This can be done by connecting to the TCP
port selected in TCPportUDPdataCtrl[x] for each UDP group. This connection is
done using TCP. The IED allows 4 concurrent client connections for every
TCPportUDPdataCtrl[x] port (for each UDP client group[x]).
If the client tries to connect on TCPportUDPdataCtrl[x] port using a PMU-ID
other than what is configured for that PMUREPORT instance
(PMUReportUDP[x]), then that client is immediately disconnected and the
UDPCtrlCfgErrCnt is incremented in PMU Diagnostics on LHMI at Main menu/
Diagnostics/Communication/PMU diagnostics/PMUSTATUS:1
Even if the parameter SendDataUDP[x] is set to Off it is still possible for the
clients to connect on the TCP port and request the configuration frames.
Protocol reporting via IEEE 1344 and C37.118
PMUREPORT
Identification
Function description
Protocol reporting via IEEE 1344 and
C37.118
Application
The phasor measurement reporting block moves the phasor calculations into an
IEEE C37.118 and/or IEEE 1344 synchrophasor frame format. The PMUREPORT
block contains parameters for PMU performance class and reporting rate, the
IDCODE and Global PMU ID, format of the data streamed through the protocol,
the type of reported synchrophasors, as well as settings for reporting analog and
digital signals.
The message generated by the PMUREPORT function block is set in accordance
with the IEEE C37.118 and/or IEEE 1344 standards.
Wide area measurement system
IEC 61850 IEC 60617
identification identification
PMUREPORT -
Section 6
GUID-0C45D2FA-1B95-4FCA-B23B-A28C2770B817 v1
GUID-0090956B-48F1-4E8B-9A40-90044C71DF20 v1
ANSI/IEEE C37.2
device number
-
GUID-8DF29209-252A-4E51-9F4A-B14B669E71AB v4
103