Table of Contents
Advertisement
MAINTENANCE
Replacing the lamp (continued)
Procedure:
1.
Switch off the power to the projector by pressing the " " button on the remote control or on the
Keypad of the projector.
2.
Allow the projector to cool down for at least 30 minutes.
3.
Disconnect the power cord.
4.
Unscrew the one screw on the cover. 1
5.
Open the cover. 2
6.
Lift up the lamp handle. 3
7.
Press on the both sides then lift up and remove the lamp cord. 4
8.
Unscrew the one screw on the lamp module. 5
9.
Lift up the lamp handle 6 and remove the lamp module slowly and carefully. 7
10.
To replace the lamp module, reverse the previous steps.
11.
Turn on the projector and reset the lamp timer.
12.
Lamp Reset: (i) Press "Menu" (ii) Select "OPTIONS" (iii) Select "Lamp Settings" (iv) Select
"Lamp Reset" (v) Select "Yes".
Notee:
‡
The screw on the lamp cover and the lamp cannot be removed.
‡
The projector cannot be turned on if the lamp cover has not been placed back on the projector.
‡
Do not touch the glass area of the lamp. Hand oil can cause the lamp shatter. Use a dry cloth to clean
the lamp module if it was accidentally touched.
64
English
2
1
3
4
5
6
7
Advertisement
Table of Contents
