Table of Contents
Advertisement
USING THE PROJECTOR
Powering off
1.
Turn off the projector by pressing the " " either on the projector keypad or the remote control.
2.
The following message will be displayed:
3.
Press the " " again to confirm otherwise the message will disappear after 15 seconds. When you
press the " " button for the second time the projector will shut down.
4.
The cooling fans will continue to operate for about 10 seconds for the cooling cycle and the On/
Standby LED will flash blue. When the On/Standby LED turns solid red the projector has entered
standby mode. If you wish to turn the projector back on, you must wait until the cooling cycle has
finished and the projector has entered standby mode. When the projector is in standby mode simply
press the " " button again to turn on the projector.
5.
Disconnect the power lead from the electrical outlet and the projector.
Notee:
(*) Optional accessory vary depending on model, specification and region.
It is not recommended that the projector is tuned on immediately following a power off procedure.
20
English
Power Off?
Press Power again
Advertisement
Table of Contents
