Table of Contents
Advertisement
Operating the TD 200
3.8
Using the TD 200 Setup Menu Option
The TD 200 Setup menu allows you to set the network address of the TD 200 and the
S7-200 CPU, the address of the parameter block (stored in V memory of the CPU), and the
baud rate for communication. The network addresses allow the TD 200 to be connected to a
network with multiple master and slave devices. Entering the address where the TD 200
looks for its parameter block allows you to have several TD 200 devices connected to a
single CPU.
Note
Pressing ESC with the cursor on the left-most character returns you to the Display
Message mode. If you change either of the setup values, the TD 200 reinitializes the
communications to the CPU.
Setting the Network Address of the TD 200
The Setup Menu allows you to enter the network address for the TD 200. (The default
address for the TD 200 is 1.) Use the following procedure to change the network address for
the TD 200:
Key
1.
ESC
2.
3.
ENTER
4.
ENTER
Note
Pressing ESC at any time while setting the network address for the TD 200 aborts the edit
and returns the cursor to the left-most character of the line.
3-16
Action
The TD 200 enters the Menu mode.
The TD 200 scrolls down the menu options
five times.
Press
to move the cursor to the
ENTER
address field. Use the up or down arrow
keys to display the correct address.
Press
to store the new address for
ENTER
the TD 200.
Display
MENU MODE:
VIEW MESSAGES
SETUP MENU:
TD 200 ADDRESS
1
SETUP MENU:
TD 200 ADDRESS
1
SETUP MENU:
TD 200 ADDRESS
2
SIMATIC TD 200 Operator Interface
C79000-G7076-C205-04
Advertisement
Table of Contents
