Table of Contents
Advertisement
Operating the TD 200
Entering a Password
To enter a password, perform the following steps.
Key
1.
2.
ENTER
Repeat this process for all eight password characters. For passwords with fewer than eight
characters, use blank spaces (the default character) by pressing ENTER for the unused
(remaining) characters. After the eighth character is entered, the TD 200 attempts to
legitimize the communication link to the CPU. If the password is incorrect, the TD 200
displays the message shown in Figure 3-3.
Figure 3-3
Incorrect Password Display
Correcting a Password
Press ESC and repeat the steps for entering a password.
3-10
Action
The TD 200 scrolls through the possible
characters for the password.
Press
when the correct character is
ENTER
found for the current password character
location. The cursor then moves to the next
character location.
SIEMENS
F5
F6
F7
F1
F2
F3
Display
PASSWORD REQUIRED
PASSWORD ********
PASSWORD REQUIRED
PASSWORD ********
TD 200
F8
F4
SHIFT
ESC
ENTER
SIMATIC TD 200 Operator Interface
C79000-G7076-C205-04
Advertisement
Table of Contents
