Using The Belt Clip; Getting Started; Setting The Recorder Date And Time (First Time Use Only) - Philips DigiTrak XT Instructions For Use Manual

Using the DigiTrak XT Recorder

Using the Belt Clip

To insert the recorder into the belt clip
Slide the belt clip over the battery end of the recorder until it snaps into place.
1
Rotate the belt clip until it locks into the desired position.
2
To remove the recorder from the belt clip
Slide the battery end of the recorder out of the belt clip.

Getting Started

The following sections describe how to set up the recorder for use.
N O T E If the recorder is turned off for any reason, for example, to shut it down early, you must remove the
battery. To restart the recorder, insert the battery and press Enter. When the recorder is powered
on, default settings are in effect; any custom settings are lost. In addition, the previous ECG recording
is erased.

Setting the Recorder Date and Time (First Time Use only)

To set the recorder date and time
N O T E Use an alkaline battery for recordings up to 96 hours. Use a lithium battery for recordings over 96
hours.
Make sure a fresh AAA battery is in the recorder.
1
N O T E The recorder enters sleep mode after 20 seconds of no activity. If this happens, simply press Enter
to turn the recorder on.
Use the arrow buttons to display the
2
Press
3
Use the
4
on), and use the
Press
5
To start a recording, display the
6
If you do not want to start a recording, remove the battery to shut down the recorder.
7
1-8 DigiTrak XT Recorder Instructions for Use
.
Enter
to select the parameter to change (hour, minute, date, and so
up and down arrows
left and right arrows
to accept the changes.
Enter
tab.
Date/Time
to change the setting of the parameter.
tab and then press
Start
to begin recording.
Enter