Step One - Connecting The Recorder To The Dual Dock - Philips DigiTrak XT Instructions For Use Manual

Step One — Connecting the Recorder to the Dual Dock
You connect the recorder to the docking station to enter patient information and to download
data collected in the DigiTrak XT recorder to the Holter application. The data is transferred to
and from the Holter system via a USB docking station. The docking station is connected to the
PC through a USB port; you place the recorder in the docking station to transfer the data. The
dual dock refers to the docking station that accommodates both the DigiTrak XT and DigiTrak
Plus recorders.
Ensure the dual dock is connected to the Holter computer before proceeding.
To connect the dual dock to the Holter computer
Plug the USB connector from the dual dock into an available USB port on the computer.
To connect the recorder to the dual dock
Remove the battery from the recorder.
1
Remove the belt clip or pouch from the recorder, if attached.
2
Do not insert the recorder at a high angle or with the pins facing out. Inserting the recorder from a
CAUTION
high angle will result in bent pins.
Gently slide the left side of the recorder straight into the dual dock station (at the angle
3
shown) with the pins facing the side (under the flap). The recorder snaps into place.
Gently press down on the right side of the recorder to lock it into the dual dock station.
4
There should be light resistance.
DigiTrak XT Recorder Instructions for Use
Getting Started
1-9