System Configuration Screen; Radio/Modem Screen Z - Microwave Data Systems iNet 900 Quick Start Manual

System Mode
Data Interface
MDS 05-2873A01, Rev. A
DRAFT 6—8/29/01
System Configuration Screen
Figure 13. System Configuration Screen
(Items discussed are outlined with red and blue.)
This screen is the location where you will check and set, if necessary,
the "System Mode". If the unit will serve as the Access Point station and
Access Point (gateway) into the IP network, click on
should only be one radio in each iNet network set to
other radios in the system should be set to
Here too is the location for choosing the primary data port for the radio.
By default, it is the
ETHERNET
RS/EIA-232 devices, click on the
button to implement the change.
Radio/Modem Screen
Figure 14. Radio/Modem Menu Items
(Item discussed are outlined with red.)
1. This direction is a guess as the setting controls are not active on my prototype.
MDS iNet 900 Installation and Operation Guide
Invisible place holder
Station
Port. If you are connecting lower speed,
button, and then the
Serial Port
1
Z?
Invisible place holder
. There
Access Point
. All
Access Point
.
Submit
23