Table of Contents
Advertisement
Racking the disk enclosure
The disk enclosure can be installed into most standard server racks. To verify that your rack is
supported for use with the disk enclosure, see the QuickSpecs for the disk enclosure, available
on the D3000 website.
CAUTION:
A disk enclosure populated with disk drives is too heavy to lift safely.
Movement of a disk enclosure during installation might damage the internal storage media
of installed disk drives.
Rack installation best practices
In addition to industry-standard recommendations, consider the following:
Locate the heaviest items, such as uninterruptible power supplies (UPS) and additional disk
enclosures near the bottom of the rack.
To make cabling easy, install the disk enclosures below the server.
Install similar components next to each other in the rack. Because disk enclosures, switches,
and servers are of differing depths, if you have more than one of a device, mount those
devices adjacent to one another to accommodate working behind the rack.
WARNING!
At least two people lift the storage system during removal or installation if the weight exceeds
22.7 kg (50 lb). If the system is being loaded into the rack above chest level, a third person
MUST assist with aligning the system with the rails while the other two people support the
weight of the system.
The leveling jacks on the rack are extended to the floor.
The full weight of the rack rests on the leveling jacks.
The stabilizing feet are attached to the rack if it is a single-rack installation.
The racks are coupled together in multiple-rack installations.
Only one component in a rack is extended at a time. A rack might become unstable if more
than one component is extended.
To prevent damage and to ease insertion of the device into the rack, support the weight of
the device and keep it level when sliding it into the rack.
Rack Installation procedures
1.
Position left and right rack rails at the desired 'U' position in the rack, adjusting the rails to
fit the rack, as needed.
Front and Rear bottom edge of the rails must align with the bottom of EIA boundary in the
lowermost 'U'
NOTE:
should be installed.
2.
Use guide pins to align the shelf mount kit to the RETMA column holes.
The bottom of the rail must align with the bottom of the U.
3.
To engage the rear, push the rail toward the back of the rack until the spring hook (1) snaps
into place.
28
Installation
Install disk drives in the enclosures only after mounting the enclosures in the rack.
To reduce the risk of personal injury or damage to the equipment, be sure that:
Rails are marked L and R with an arrow indicating the direction in which the rail
Hide quick links:
Advertisement
Table of Contents
