Advertisement
Version History
Software
Hardware
Original Date of
Version
Suffix
Issue
Major Minor
50
L
A
April-2017
51
A
A
Sep-13
51
B
A
Nov-13
51
C
A
June-14
52
B
A
Nov-13
4
Relay type: Agile P14N, P14D and P94V
Permanent ethernet communication loss in P40 Agile relays
Maintenance Record Generated Everytime Gateway is configured in DNP configuration
CS1 and CS2 does not work independently whey CB Comp enabled for CS2
· Ethernet Enhancements for the P94V
· New model P14DA
· Neutral Admittance Protection for the P14DL and P14DZ
· Selectable Measured/Derived NVD.
Undervoltage programmable curve not using standard template used by other Px4x relays
The map of IEC 61850 data model for P34x has errors in Function
With e-terra scada system, the P40 Agile data model extraction stops at Measurments/PriFouMMXU1$CF
When using SBOns control model for the data 'Control/XCBR1$CO$Lock' and both Check Conditions are set the
Agile relay is dropping the connection to the client.
DNP ALSTOM rebranding in dnpev_devattr.h
QNX kernel can delay user threads for up to 10ms.
Unextracted events are lost on RP1, following relay reboot, using a DNPOE build.
Incorrect response to Object 2 Variation 3 request for Binary Input Event with Relative Time
ISEF, IEF and anything related are not scaled properly when the CT ratio is 5A.
IEEE Floats are wrong at modbus interface.
Ethernet application (IEC61850 + DNP3oe) crashes if a Courier tunnel is continuously opened/closed (as done by
S1 Agile Measurements viewer).
EF directional function fail to trip
The VCO Status, cell [3582], for the Voltage Controlled Overcurrent isn't updated after a change. The change
takes effect after a power cycle or change to V Dep
Object 0 variations: 219, 222, 245 & 247 are incorrect.
ZR0006 FCT fails; High current drain to opto transformer drive circuit
· Chinese HMI Added
· The DDB 1599-1798 display "PSL internal 001-200", but DDB 923-1022 still display "PSL internal 001- 100". Have
duplicate content.
The VCO Status isn't updated after a change. The edited change does take effect after a power-cycle or a change
to "V Dep OC V<1 Set" cell 3583.
Object 0 variations: 219, 222, 245 and 247 are incorrect.
Description of Changes
P40 Agile P14D, P14N, P94V
Technical Documentation
P14D-TM-EN-1
P14N-TM-EN-1
P94V-TM-EN-1
P14D-TM-EN-1
P14N-TM-EN-1
P94V-TM-EN-1
P14D-TM-EN-1
P14N-TM-EN-1
P94V-TM-EN-1
P40Agile-VH-EN-9
Advertisement
