DigiTech TRIO+ Band Creator+ Looper Owner's Manual page 14

15. BAND Footswitch & LED
Pressing this footswitch changes the TRIO+'s state. It is used to teach the band, start and stop band and
loop playback, and clear the band. See 'Teaching The TRIO+ Band' on page 17 for more information.
The BAND LED indicates the status of the band for the selected song part. The following table describes the
available states of the BAND LED.
BAND LED
Slowly
Flashing Red
Rapidly
Flashing Red
Solid Bright
Red
Solid Bright
Green
Solid Dim
Green
11
State
The selected song part has not yet been learned by the TRIO+. Press
the BAND footswitch to arm the TRIO+ for learning. Note that the
Band Hasn't
TRIO+ cannot learn a song part if a loop has already been recorded
Learned Part
with no backing band. In this case, the loop must first be cleared
before the TRIO+ will be able to learn the part.
Band Armed
The TRIO+ is armed and waiting for you to start playing so it can
& Ready To
learn your song part.
Learn
The TRIO+ is currently learning the song and you should be playing
to teach the TRIO+ the chords and timing. Pressing the BAND
Band
footswitch will stop the learning phase and begin band playback. In
Learning
the event you make a mistake, holding the BAND footswitch for 2
seconds will quickly clear the learned part so you can try again.
The TRIO+ is playing the song. Pressing the BAND footswitch will
Band Playing stop band playback. Holding the BAND footswitch for 2 seconds
will queue up the next learned part for automatic playback.
The TRIO+ has learned the selected song part, but band and loop
playback is stopped. Press the BAND footswitch to start band and
loop playback. Or, while stopped, hold the BAND footswitch for 2
Band
Stopped seconds to clear the selected part and loop. Immediately hold the
BAND footswitch again for 2 seconds to restore the cleared part
and loop.
Description