Windshield - Yamaha Super Tenere XTZ12H 2016 Owner's Manual

Instrument and control functions
1
4
1. Rider seat height position adjuster
3. Install the rider seat height posi-
tion adjuster so that the match
mark is aligned with the "H" mark
as shown.
1
2
1. Rider seat height position adjuster
2. "H" mark
3. Match mark
4. Insert the projection on the rear of
the rider seat into seat holder B as
shown.
1. Projection
2. Seat holder B (for high position)
TIP
3
Make sure that the rider seat is proper-
ly secured before riding.

Windshield

To suit the rider's preference, the wind-
shield can be changed to one of four
positions.
1
To adjust the windshield height
2
1. Loosen the windshield height po-
1. Windshield height position adjusting knob
2. Pull the slide plate holders out-
4-33
sition adjusting knob on each side
of the windshield until resistance
is felt. NOTICE: Do not continue
turning the knob after resis-
tance is felt. Otherwise, the
knob could be damaged.
1
ward, and then adjust the height of
the windshield.
EAU58982
[ECA20211]