Windshield - Yamaha Super Tenere ES 2023 Owner's Manual

Windshield

To suit the rider's preference, the wind-
shield can be changed to one of four
positions.
To adjust the windshield height
1. Loosen the windshield height po-
sition adjusting knob on each side
of the windshield until resistance
is felt. NOTICE: Do not continue
turning the knob after resis-
tance is felt. Otherwise, the
knob could be damaged.
1. Windshield height position adjusting knob
2. Pull the slide plate holders out-
ward, and then adjust the height of
the windshield.
1. Slide plate holder
3. Align the slide plate holders with
the match marks at the desired
position.
Instrument and control functions
EAU58982
[ECA20211]
1
1
4-34
TIP
 Make sure that the slide plate
holders are aligned with the match
marks at the same height on both
sides of the windshield.
 Make sure that the projection on
each slide plate holder fits into the
corresponding hole in the slide
plate.
1
1. Match mark
2. Slide plate
4. Tighten the adjusting knobs.
2
4