Table of Contents
Advertisement
If you touch
you set the DURATION, the
appliance switches to the
setting of the END function.
6. When the set time ends, an acoustic
signal sounds for two minutes.
and time setting flash in the display. The
appliance deactivates.
7. Touch a sensor field or open the oven
door to stop the acoustic signal.
8. Deactivate the appliance.
Setting the END
1. Activate the appliance and set an oven
function and temperature.
2. Touch
again and again until the
display shows
flashes in the display.
3. Use
or
to set the END and
or
to confirm. First you set the
minutes and then the hours.
When the set time ends, an acoustic signal
sounds for two minutes.
time setting flash in the display. The
appliance deactivates.
4. Touch a sensor field or open the oven
door to stop the acoustic signal.
5. Deactivate the appliance.
Setting the SET+GO
You can use the SET+GO function only
when the DURATION is set.
1. Set an oven function (or a programme)
and temperature.
2. Set the DURATION.
3. Touch
again and again until
flashes in the display.
4. Touch
to set the SET+GO function.
The display shows
indicator. This indicator shows which clock
function is activated.
or
while
.
symbol and the
and
with an
5. Touch a sensor field (apart from ON /
OFF) to start the SET+GO function.
Setting the MINUTE MINDER
Use the MINUTE MINDER to set a
countdown (maximum 2 h 30 min). This
function has no effect on the operation of
the oven. You can set the MINUTE MINDER
at any time and also when the appliance is
off.
1. Touch
.
and "00" flash in the display.
2. Use
or
to set the MINUTE
MINDER. First you set the seconds,
then the minutes and the hours.
3. Touch
or the MINUTE MINDER
starts automatically after five seconds.
When the set time ends, an acoustic signal
sounds for two minutes and 00:00 and
flash in the display.
4. Touch a sensor field or open the oven
door to stop the acoustic signal.
Setting the Time delay function
The DURATION
used at the same time, if the appliance is to
be switched on and off automatically later.
In this case, first set the DURATION
then the END
function (refer to "Setting
the DURATION" and "Setting the END" ).
When the Time delay function is
activated, the display shows a
static symbol of the oven
function,
The dot shows which clock
function is on in the Clock /
residual heat display.
Progress 13
and END
can be
with a dot and
.
and
Advertisement
Table of Contents
