Telrad BreezeCOMPACT System Manual page 91

Chapter 3 - Operation and AdministrationBS Menu
Chapter 3 - Operation and Administration
A change in Service Flow Traffic Priority will take effect after next reset.
3.7.2.6.3.3.6 Service Flow Media Flow Type
The Service Flow Media Flow Type, as defined in ASN-GW or AAA server. Optional parameter
(depending on value configured for Enable Service Flow Media Flow Type below), up to 32 characters.
A change in Service Flow Media Flow Type will take effect after next reset.
3.7.2.6.3.3.7 Enable Service Flow Media Flow Type
Indicates whether the condition for Service Flow Media Flow Type is enabled or disabled. If true, the
Service Flow Media Flow Type will be considered. when looking for a match.
A change in Enable Service Flow Media Flow Type will take effect after next reset.
3.7.2.6.3.3.8 Outer DSCP Marking
The DSCP value to be used for marking the outer IP header (IP/GRE). The range is 0-63.
A change in Outer DSCP Marking will take effect after next reset.
3.7.2.6.3.3.9 802.1p Priority Marking
The 802.1p priority to be used for marking traffic. The range is 0-7.
A change in 802.1p Priority Marking will take effect after next reset.
3.7.2.6.4 ASN-GW Load Balancing
At the BTS level, up to two pools (with different priorities), each with up to 10 ASN-GWs, can be defined
(see "ASN-GW Load Balancing Pools" on page
the ASN-GW defined in the BS as the Default Authenticator will be automatically added to the Primary
Pool that is the higher priority pool (although it will not be shown as belonging to the pool).
At the BS level, you can enable/disable the use of each of the two pools. The Secondary Pool can be
enabled only if the Primary Pool is enabled and includes at least one entry. Note that if both pools are
disabled, or if the enabled pool(s) are empty, the ASN-GW load balancing feature is disabled and only
the Default Authenticator will be used.
The ASN-GW Load Balancing menu includes the following options:
Pools Availability
Primary Pool
Secondary Pool
3.7.2.6.4.1 Pools Availability
The Pools Availability option enables viewing/updating the status (Enabled/Disabled) of each of the
pools. The Secondary Pool can be enabled only if the Primary Pool is enabled.
A change in a Pool Availability will take effect after next reset.
3.7.2.6.4.2 Primary Pool
The Primary Pool option enables viewing the IP Address and current Connectivity Status for each of the
ASN-GWs in the pool, based on selection of the ASN-GW Index.
BreezeCOMPACT System Manual
49). The BS will "inherit" these pools. It should be noted
BS Menu
77