Connectivity - Telrad BreezeCOMPACT System Manual

Chapter 3 - Operation and AdministrationBTS Menu
Chapter 3 - Operation and Administration
3.5.1.5 Legacy ASN-GW Mode
The Legacy ASN-GW Mode defines functionality supported by the external ASN-GW:
Select enable if using a Cisco ASN GW (supports only IP CS services). BS should support only IPv4
CS-type. It means BS should verify whether this type is received from CPE within the registration request
and if so include it in the attachment request towards the ASN-GW. All other CS types supported by CPE
and received in registration request will be ignored and not forwarded to the ASN-GW.
Select disable if using any other approved ASN GW. BS should support the following CS-types: IPv4,
Ethernet, VLAN, IPv4-over-Ethernet, Pv4-over-VLAN. This means it should verify whether these types are
received from CPE within the registration request and if so include them in the attachment request
towards the ASN-GW. All other CS types supported by CPE and received in registration request will be
ignored and not forwarded to the ASN-GW.
The default is disable.
A change in Legacy ASN-GW Mode will take effect after next reset.
3.5.2

Connectivity

The Connectivity submenu includes the following options:
Management Interface
IP Interfaces
L1 & L2
ASN-GW Load Balancing Pools
QoS Marking Rules
3.5.2.1 Management Interface
The system uses different IP domains for the following traffic types:
Bearer IP domain for subscriber data and ASN/CSN control traffic.
External Management domain for remote management traffic.
Local Management domain for local (direct) management traffic.
The unit supports the following IP connectivity modes:
Out Of Band: In the Out Of Band connectivity mode different Ethernet ports are used for bearer traffic
and external management traffic.
In Band: In the In Band connectivity mode the sane Ethernet port is used for both bearer traffic and
external management traffic. VLANs are used to differentiate between the two traffic types. The
bearer VLAN ID is used for the bearer traffic and the external management VLAN ID is used for the
external management traffic.
BreezeCOMPACT System Manual
BTS Menu
44