Telrad BreezeCOMPACT System Manual page 62

Chapter 3 - Operation and AdministrationBTS Menu
Chapter 3 - Operation and Administration
Out of Band Connectivity Mode: Data Port 1 or Data Port 2 is used for tagged bearer traffic (see
Negotiation Mode" on page 48
applicable). Data Port 3 is used for tagged external management traffic and for untagged local
management traffic.
In Band Connectivity Mode: Data Port 1 or Data Port 2 is used for both bearer and external
management traffic. VLANs are used to separate the two traffic types. Data Port 3 is used for
untagged local management traffic.
Unified Connectivity Mode: Data Port 1 or Data Port 2 is used for both bearer and external
management traffic. Both traffic types share the same VLAN. Data Port 3 is used for untagged local
management traffic.
If an SFP is installed in DAT1, the selection between Data Port 1 and Data Port 2 will be based on
automatic Ethernet activity detection (only one of these ports can be active).
CAUTION
If you want to switch from Data Port 1 to Data Port 2 (or vice versa), the unit must be reset (or
powered-down and then powered-up) after physically connecting to the new port.
The L1 & L2 option enables selecting any of the applicable ports for viewing or updating the following
parameters:
Operational State
Port Negotiation Mode
Port Speed
Duplex Mode
Actual Duplex Mode: Read-only. The actual duplex mode of the port (none if the port is down)
Actual Speed: Read-only. The actual speed of the port (0 if the port is down)
3.5.2.3.1 Operational State
The Operational State parameter is applicable only for Show menu, indicating the current operational
status of the port (Up or Down).
3.5.2.3.2 Port Negotiation Mode
The mode for negotiating the port speed and the duplex mode with the link partner (Auto or Manual).
The Port Speed and Duplex Mode parameters are configurable only if Port Negotiation Mode is Manual.
The default for all ports is Auto.
For Data Port 1, if the Operational State is Up Negotiation Mode is forced to Auto.
3.5.2.3.3 Port Speed
The port speed to be used for the physical interface.
BreezeCOMPACT System Manual
for details on selecting the active port when both port are
BTS Menu
"Port
48