Step 3 - Telephone Endpoint Connection - Xblue Networks x16 Installation Manual

X16 Installation Guide
CO Line Cadence and Status Table
Speaker Unlit: Speaker or Intercom Link Idle
Fast: Receiving incoming call
Lit: Talking with the Digital Telephone Endpoint
Slow: In headset mode
Enter/VM Unlit: No New messages
Fast: New Message in VM
Lit: No answer forward active – unanswered calls will be
forwarded to VM
Slow: New Telephone Company Line Message Waiting
Mute Unlit: Inactive – phone is not muted
Lit: Active – phone is muted
All Page Unlit: Inactive – Not currently paging
On Flexible Button Lit (rapid flash): Making or receiving a page
DND Unlit: Inactive – DND function is off
On Flexible Button Lit (solid): Active – DND function is active
Record Unlit: Inactive – Not recording call
On Flexible Button Lit (rapid flash): Active – Recording call
Headset Unlit: Headset function is off
On Flexible Button Lit: Headset function is on
DSS/BLF Unlit: The extension programmed on the button is idle
On Flexible Button Lit: The extension programmed on the button is busy
Slow: The extension programmed on the button is in DND
Ringing Cadence
CO Ring Synchronized with CO Ringing
Intercom Ringing 0.25 sec on, 0.25 sec off, 0.25 sec on, 1.25 sec off repeating.
Transfer/Recall 1 sec on, 1 sec off, repeating
Hold Reminder 1100Hz, 0.05 sec on/off, 4 beeps
Privacy Release 1100Hz, 0.2 sec on/off, 1 beep
Privacy Recover 1100Hz, 0.2 sec on/off, 2 beep
Call Waiting Beep 500Hz, 0.2 sec on/off, 2 beeps
Single/All Page 600Hz, 1.0 sec on, 1 beep
Confirmation Beep 1100Hz, 0.5 sec on, 1 beep
Warning Beep 1100Hz, 0.05 sec on/off, 3 beeps
Cable Specifications
Category AWG
CAT5e 24
- 58 -
Length Impedance
600 feet 20 Ohms
Issue 2
Step 3 – Telephone Endpoint Connection
The X16 comes standard with four RJ11 extension ports. Each port supports
up to 4 proprietary digital telephone endpoints, for a total of sixteen (16)
endpoints. Each port on the system will support up to 600 feet of cable.
In a Loop wiring or serial cable topology 600 feet is calculated by adding
the distance of the initial run plus the distance between each telephone.
Cable A to telephone 1 + (distance between telephone1 & telephone 2) +
(distance between telephone 2 & telephone 3) + (distance between
telephone 3 & telephone 4) <= 600 feet.
Issue 2 - 15 -