Switching The Wireless Headphone System Off; Attaching The Receiver To Clothing - Sennheiser Flex 5000 Manual

Flex_5000_570735_0117_PRT.book Seite 16 Montag, 10. Oktober 2016 3:58 15
EN Using the Flex 5000

Switching the wireless headphone system off

Place the receiver into the transmitter's charging compart-
ment.
The receiver switches off. The
The charging process starts (see page 11).
Or, if you want to switch the receiver off without placing it
into the transmitter's charging compartment:
Speech intelligibility
Press the
The receiver switches off. The
The transmitter automatically switches off (standby)
when there is no receiver connected. The
tus
LED goes off.
Always store the receiver in the transmitter's charging
compartment to ensure that it is fully charged when
needed.
* LED goes off
If the receiver is outside the transmission range for
more than 5 minutes or if the transmitter receives no
audio signal for more than 30 minutes, the wireless
headphone
(standby).
To disconnect the transmitter from the power supply system
(e.g. when you are on holiday):
Unplug the power supply unit from the wall socket.

Attaching the receiver to clothing

Depending on the connected headphones or induction loop,
please observe the following attachment recommendations
for your receiver:
• Place the receiver next to you so that you can take it in
your hand and operate it.
• Use the clip to attach the receiver to your clothing. Make
sure that the headphone cable does not hinder your move-
16 | Flex 5000
Receiver status
button for 2 seconds.
Receiver status
OFF
system switches
LED goes off.
LED goes off.
Transmitter sta-
2s
off automatically