Displaying The Remaining Operating Time Of The Rechargeable Battery - Sennheiser Flex 5000 Manual

Flex_5000_570735_0117_PRT.book Seite 12 Montag, 10. Oktober 2016 3:58 15
EN Putting the Flex 5000 into operation
Battery
LED
Battery
LED flashes
rapidly
Always store the receiver in the transmitter's charging
compartment to ensure that it is fully charged when
needed. The intelligent battery charging technology
prevents overcharging.
The display during charging can be set so that it auto-
matically switches off after 30 seconds (see page 27).
Displaying the remaining operating time of the
rechargeable battery
When you switch the receiver on, the
the remaining operating time/charge status.
Battery
LED
Battery
LED flashes slowly
st
1 segment lit
st nd
1 + 2 segments lit
All segments lit
To indicate that the operating time is decreasing, each LED
segment slowly dims before it goes off completely.
If the actual operating time differs widely from the specified
values, the rechargeable battery is probably exhausted and
should be replaced. Information on the rechargeable battery
can be found on page 24.
The display of the remaining operating time can be set
so that it automatically switches off after 30 seconds
(see page 27).
If more than one receiver is connected to the transmit-
ter, the remaining operating time/charge status cannot
be displayed.
12 | Flex 5000
Meaning
A charging error/battery error has
occurred (see page 24).
Battery
Meaning
Rechargeable battery is empty;
recharge it
approx. 4 hrs of operating time
approx. 8 hrs of operating time
approx. 12 hrs of operating time
LED displays