Table of Contents
Advertisement
Available languages
Available languages
SWEEPER OPERATION
1.
If necessary, adjust the handlebar (1) to one of the 3 positions, by using the knobs (2).
2.
Grab the handlebar and push the machine forward no faster than a normal walking pace. The machine does not work if
dragged backwards.
CAUTION!
If the machine is to be used on wet loors, use it only for short intervals.
3.
The hopper (3) should be emptied after each working cycle and whenever it is full.
NOTE
When the hopper is full, the machine cannot collect dust and debris anymore.
HOPPER EMPTYING
1.
Lift the hopper with the handle (4) in the front side and empty it into a proper container.
2.
Install the hopper on the machine by inserting the lower end into the machine frame (12).
Slightly press downwards until the hopper is in the proper position.
3.
It is advisable to empty the hopper after each use and whenever it is necessary.
AFTER USING THE MACHINE
After working, before leaving the machine: empty the hopper (4) and check the main brooms (8 and 9) to remove foreign
materials (lace, wire, strings or similar) which can compromise the proper operation.
To store the machine in a narrow place, fold the handlebar (1).
–
Loosen the knobs (2) and pull the handlebar upwards.
–
Fold down the handlebar and lock it.
Then place the machine in a vertical position to preserve the broom bristles.
MAINTENANCE
CAUTION!
Only perform the maintenance procedures described in this Manual.
For other procedures, contact the Service Center.
Use only Clarke original spare parts and accessories.
The lifespan of the machine and its maximum operating safety are ensured by correct and regular maintenance.
SCHEDULED MAINTENANCE TABLE
Procedure
Place the machine in a vertical position
Empty the hopper (3)
Clean the main (8 and 9) and side brooms (6)
Clean the machine
Replace the main broom (9) when worn
Replace the side brooms (6) when worn
Replace the driving belt
(*)
Contact an authorised Service Center or Retailer.
SWEEPER MAINTENANCE
After each use, perform the following procedures:
–
Empty the hopper (3).
–
Check if there are foreign objects caught in the brooms or wheels and remove them immediately.
Clean the brooms and remove any lace, wire, strings or similar, which can compromise the machine eficiency and cause
–
damages due to the drive system sticking.
–
Periodically check the main and side brooms for wear ; adjust their height or replace them when the sweeping capacity is
reduced.
Operator's Manual - SW 26
After working
ENGLISH
Monthly
When necessary
5
(*)
Advertisement
Chapters
Table of Contents
