Final Work - Webasto Thermo Top E Installation Documentation

Audi A3

Final Work

WARNING!
Reassemble the disassembled components in reverse order. Check all hoses, clamps and all electrical
connections for firm seating. Secure all loose lines using cable ties.
Only use manufacturer-approved coolant. Spray the heater components with anti-corrosion wax
(Tectyl 100K, Order No. 111329).
- Connect the battery
- Fill and bleed the coolant circuit according to the vehicle manufacturer's specifications.
- Set the digital timer.
- Make settings on A/C control panel according to the "Operating Instructions for End Cus-
tomer".
- Place the "Switch off parking heater before refueling" signboard in the area of the filler
neck
- Check the proper function of the parking heater, see the operating instructions/installation
instructions.
- Proceed with the Webasto Thermo Test Diagnostics as follows at the initial start-up:
 Pump up fuel for heater under the pipeline filling button
 CO
- Check setting, adjustment values are listed in the General Installation Instructions
2
 During the test run, check all water and fuel connections for leaks
and firm seating
 Conduct troubleshooting in case of any malfunctions
Adjust the sensitivity of the passenger compartment monitoring
WARNING!
Pass through can only be carried out at an authorized workshop. Observe the applicable repair manual
of the respective vehicle.
- Connect the VAS tester.
- Open Item 46 (Central Module of Comfort System)
- Go to Item 10 (Adjustment)
- Follow the request for the code entry and enter the code 15
- Reduce the sensitivity of the passenger compartment monitoring to 50 %
- Save this setting
- The adjustment of the sensitivity of the passenger compartment monitoring is completed.
1313622D_EN
Webasto AG
Postfach 80
D-82132 Stockdorf / Germany
National Hotline: 01805 93 22 78
(14 Cent aus dem deutschen Festnetz)
Hotfax: 0395 5592 353
Hotmail: technikcenter@webasto.com
http://www.webasto.com
Printed in Germany
Feel the drive
04/2012 Printing: Steffen
30