Ubuntu Core 16; Default Bios Settings; General (Bios Level 1) - Dell Edge Gateway 3003 Installation And Operation Manual

6. Secure a crossover network cable between Ethernet port two on the Edge Gateway and the configured Ethernet port on the
computer.
7. On the Windows computer, launch Remote Desktop Connection.
8. Connect to the Edge Gateway using the IP address 192.168.2.1. The default username and password are both admin.

Ubuntu Core 16

Boot up and log in – Remote system configuration
1. Connect a network cable from Ethernet port one on the Edge Gateway to a DHCP-enabled network or router that provides IP
addresses.
2. In your network's DHCP server, use the command dhcp-lease-list to obtain the IP address associated with the Edge
Gateway's MAC address.
3. Setup as SSH session using an SSH terminal emulator (for example, native command-line ssh client on Linux or PuTTY on Windows).
NOTE: The SSH service is enabled on Ubuntu Core 16 by default.
4. Enter the command ssh admin@
password are both admin.
For example;
lo@lo-Latitude-E7470:~$ ssh admin@10.101.46.209
admin@10.101.46.209's password:
Boot up and log in – Static IP system configuration
This allows you to connect your Edge Gateway through a host computer, which must be on the same subnet.
NOTE: The static IP address of Ethernet port two on the Edge Gateway is set to these values at the factory:
• IP address: 192.168.2.1
• Subnet mask: 255.255.255.0
• DHCP server: Not applicable
1. On the host computer, configure the Ethernet adaptor that is connected to the Edge Gateway with a static IPv4 address under the
same subnet. Set the IPv4 address to 192.168.2.x (where x represents the last digit of the IP address, for example,
192.168.2.2).
NOTE: Do not set the IPv4 address to the same IP address as the Edge Gateway. Use an IP address between 192.168.2.2
to 192.168.2.254.
2. Set the subnet mask to 255.255.255.0.

Default BIOS settings

General (BIOS level 1)

Table 22. General (BIOS level 1)
BIOS level 2
System Information
<IP address> , followed by the default user name and password. The default user name and
BIOS level 3
System Information
Memory Information
Item
BIOS Version
Service Tag
Asset Tag
Ownership Tag
Manufacturing Date
Ownership Date
Express Service Code
Memory Installed
Default value
Not applicable
Not applicable
Not applicable
Not applicable
Not applicable
Not applicable
Not applicable
Not applicable
69