Dell Edge Gateway 3003 Installation And Operation Manual page 53

6. Stop scanning after the Bluetooth keyboard is found.
$ scan off
7. Pair Bluetooth devices.
$ pair <MAC address of Bluetooth keyboard>
8. Enter PIN code on the Bluetooth keyboard, if required.
9. Trust the Bluetooth keyboard.
$ trust <MAC address of Bluetooth keyboard>
10. Connect to the Bluetooth keyboard.
$ connect <MAC address of Bluetooth keyboard>
11. Close the bluetoothctl console.
$ quit
You can start using the Bluetooth keyboard.
Switching between WLAN and Bluetooth modes
1. Unload the WLAN/BT driver.
$ modprobe -r ven_rsi_sdio
2. Adjust the mode in /etc/modprobe.d/rs9113.conf
3. Reload the WLAN/BT driver.
$ modprobe ven_rsi_sdio
4. Verify the operation mode. Refer to the table for operating mode values.
$ cat /sys/module/ven_rsi_sdio/parameters/dev_oper_mode
Table 8. Operating mode values for WLAN and Bluetooth
Operating mode value
1
1
13
14
5
6
Software enabled Access Point (SoftAP)
The Software enabled Access Point (SoftAP) feature depends on the Wi-Fi card and associated driver support to act as a wireless access
point.
Run the following commands:
1. Check the access point status.
$ wifi-ap.status
2. By default, SoftAP is disabled. Turn on SoftAP.
$ wifi-ap.config set disabled=false
3. To secure the Wi-Fi access point with WPA2 personal, change two configuration items.
$ wifi-ap.config set wifi.security=wpa2 wifi.security-passphrase=Test1234
This enables WPA2 security with the passphrase set to Test1234.
NOTE: If the passphrase contains any special characters or space, ensure that it is added correctly. For example 'My WiFi', 'Pa
$$word', or "Alan's AP".
WiFi station
X
X
X
BT/BLE modes supported softAP
N/A
N/A
Dual (BT classic and
BTLE)
Dual (BT classic and
BTLE)
BT Classic
BT Classic
X
X
X
Clients supported by
softAP
N/A
32
N/A
4
N/A
32
53