Belt Clip Installation And Removal; Mic/Sp Cap Installation - Vertex Standard EVX-539 Operating Manual

Belt Clip Installation and Removal

 To install the Belt Clip: align
the Belt Clip to the groove of
the Battery pack, then press
the Belt Clip downward until it
locks in place with a "Click."
6
B Y B
EForE ou
 To remove the Belt Clip: use a
flat head screw driver to press
the Belt Clip Tab away from
the battery pack to unlock the
Belt Clip, then slide the Belt
Clip upward to remove it.
Belt Clip Tab
EgIn

MIC/SP CAP Installation

Install the MIC/SP cap with the
supplied screws.
 Use only the supplied screws
when install the MIC/SP cap.
 This radio does not keep the
submersible Rating (IP57: 1
meter / 30 minutes) when the
MIC/SP cap is not installed
in the MIC/SP jack.
EVX-539 O
FCC ID: AXI11154620
IC: 10239A-11154620
M
pErating anual