Vertex Standard EVX-539 Operating Manual page 26

rEsEt
Press (or press and hold) the assigned PF key to reset
the RFC (Ready for Communication) condition.
c 1 c 5
all to all
Press, (or press and hold), the assigned PF key to
send a pre-defined 2-tone Sequential Tone Group (on
an analog channel) or a pre-defined Digital Contact
List (on a digital channel).
c u /d
odE p oWn
Press, (or press and hold), the assigned PF key to
select a 2-Tone or 5-Tone encode code from the pre-
programmed encode list.
c s
odE Et
You can change the desired digit of the 5-Tone en-
code code using this function:
 Press, (or press and hold), the assigned PF key.
 Enter the desired 5-Tone encode code directly
from the keypad ([ 0 ] - [ 9 ] key and [ Ý ] ( wild
card ) key ) .
 Press the [ D ] key to store the new setting. The
display indicates "- SET -" briefly, then reverts to
the normal channel indication.
24
a o
dvancEd pEratIon
You may cancel the new setting by pressing
the [ C ] key. In this case, the display indicates
"- CANCEL -" briefly.
s
pEEd
Your Vertex Standard dealer may have pre-pro-
grammed Auto-Dial telephone number memories into
your radio.
To dial a number, press, (or press and hold), the as-
signed PF key, then press the keypad ([ 0 ] - [ 9 ] key )
corresponding to the Auto-Dial memory number list
provided by your Vertex Standard dealer or Network
Administrator. The DTMF tones sent during the dial-
ing sequence will be heard in the speaker.
dtmF c
 Press, (or press and hold), the assigned PF key to
start entering the DTMF dialing sequence.
 Enter the DTMF digit directly from the keypad
([ 0 ] - [ 9 ] key ) .
 After entering all DTMF digits, press the PTT
switch to transmit the DTMF code.
d
Ial
s
odE Et
EVX-539 O
pErating
FCC ID: AXI11154620
IC: 10239A-11154620
M
anual