Vertex Standard EVX-539 Operating Manual page 22

d cH E
IrEct ntrY
You can recall the desired channel directly using this
function:
 Press, (or press and hold), the assigned PF key.
A tone will sound, and the current group/channel
will appear on the display.
 Enter the desired group number (two digits) and
channel number (two digits) from the keypad ([ 0 ]
- [ 9 ] key ) .
 Press the [ D ] key to store the new setting. The
display indicates "- SET -" briefly, then reverts to
the normal channel indication.
You may cancel the new setting by pressing
the [ C ] key. In this case, the display indicates
"- CANCEL -" briefly.
s
can
The Scanning feature is used to monitor multiple
signals programmed into the transceiver. While scan-
ning, the transceiver will check each channel for the
presence of a signal, and will stop on a channel if a
signal is present. EVX-539 can scan both digital and
analog frequency programmed channels simultane-
ously.
20
a o
dvancEd pEratIon
To activate scanning:
 Press, (or press and hold), the assigned PF key to
activate scanning.
 The scanner will search the channels of each
channel, looking for active ones; it will pause
each time it finds a channel on which someone is
speaking.
 Press again, (or press and hold again), the as-
signed PF key to disable scanning. Operation will
revert to the programmed revert channel.
Note: Your dealer may have programmed your radio
to stay on one of the following channels if you press
the PTT switch during scanning pause:
 "Scan Pause" channel ("Talk Back")
 "Last Busy" channel
 "Priority-2" channel
 "User Programmed" channel ("Select Channel")
 The channel which defined in the CH Selector
knob.
EVX-539 O
pErating
FCC ID: AXI11154620
IC: 10239A-11154620
M
anual