Setting The Flash Time; Setting The Area Code - Motorola L601BT User Manual

2. Press MENU to select DIAL MODE.
3. Press MENU and then VOL+ or REDIAL/VOL- to
select TONE or PULSE.
4. Press MENU to save.
NOTE
If the pulse mode is selected, press TONE/ * to switch
from pulse to tone dialing temporarily when dialing
out. After the call is ended, the dial mode will change
back to pulse.

3.16.2 Setting the flash time

The default flash time is 600MS. It is unlikely that you
should need to change this setting unless advised to
do so.
1. Press MENU and then VOL+ or REDIAL/VOL- to
select SETUP BS.
2. Press MENU and then VOL+ or REDIAL/VOL- to
select FLASH TIME.
Using the phone
3. Press MENU and then VOL+ or REDIAL/VOL- to
the flash time you want. (8 options are available :
90, 100, 110, 250, 300, 400, 600 and 700MS)
4. Press MENU to save.

3.16.3 Setting the area code

1. Press MENU and then VOL+ or REDIAL/VOL- to
select SETUP BS.
2. Press MENU and then VOL+ or REDIAL/VOL- to
select AREA CODE.
3. Press MENU and then enter the area code.
4. Press MENU to save.
33