Three-Party Conference Call; Setting The Dial Mode; Setting The Flash Time - Motorola L701 User Manual

4. When the other handset answers by pressing
or /SPEAKER, press
call. If the other handset does not answer, press
MUTE to talk to your caller again.

3.14.3 Three-party conference call

1. During an external call, press INT.
- Your caller is put on hold.
2. Press VOL+ or REDIAL/VOL- to select the handset you
want to call.
3. Press MENU to call the handset.
4. When the other handset answers the intercom call,
press MENU on the calling handset to set up the
conference call.
5. Press /BACK on any handset to end a three-party
conference call and leave the other handset engaged
with the caller.
NOTE
During an external call, pressing
SPEAKER on any handset will join in the call and set up a
conference call.
20
/FLASH
/BACK to transfer the
/
/FLASH or /
3.15

Setting the dial mode

The default dialing mode is suitable for your country and
network operator. It is unlikely that you should need to
change this setting unless advised to do so.
1. Press MENU and then VOL+ or REDIAL/VOL- to select
SETUP BS
.
2. Press MENU to select
3. Press MENU and then VOL+ or REDIAL/VOL- to select
TONE PULSE
or .
4. Press MENU to save.
NOTE
If the pulse mode is selected, press TONE/* to switch from
pulse to tone dialing temporarily when dialing out. After the
call is ended, the dial mode will change back to pulse.
3.16

Setting the flash time

600MS
The default flash time is
need to change this setting unless advised to do so.
1. Press MENU and then VOL+ or REDIAL/VOL- to select
SETUP BS
.
DIAL MODE
.
. It is unlikely that you should
Using the phone