3.15 Base settings
3.15.1 Setting the dial mode
The default dialing mode is suitable for your country and network operator. It is
unlikely that you should need to change this setting unless advised to do so.
1. Press MENU and then VOL+ or REDIAL/VOL- to select
2. Press SELECT to select
3. Press SELECT and then VOL+ or REDIAL/VOL- to select
4. Press SELECT to save.
NOTE
If pulse mode is selected, press TONE/* to switch from pulse to tone dialing
temporarily when dialing out. After the call is ended, the dial mode will change
back to pulse.
3.15.2 Setting the flash time
The default flash time is 600MS. It is unlikely that you should need to change this
setting unless advised to do so.
1. Press MENU and then VOL+ or REDIAL/VOL- to select
2. Press SELECT and then VOL+ or REDIAL/VOL- to select
3. Press SELECT and then VOL+ or REDIAL/VOL- to the flash time you want.
(8 options are available: 90, 100, 110, 250, 300, 400, 600 and 700MS)
4. Press SELECT to save.
3.15.3 Setting the area code
1. Press MENU and then VOL+ or REDIAL/VOL- to select
2. Press SELECT and then VOL+ or REDIAL/VOL- to select
3. Press SELECT and then enter the area code.
4. Press SELECT to save.
Using the phone
DIAL
MODE.
SETUP
BS.
TONE
or PULSE.
SETUP
BS.
FLASH
TIME.
SETUP
BS.
AREA
CODE.
31