3.14.3
Three-party conference call
1.
During an external call, press INT. Your caller is put on hold.
2.
Press VOL+ or REDIAL/VOL- to select the handset you want to call.
3.
Press MENU to call the handset.
4.
When the other handset answers the intercom call, press MENU on the calling
handset to set up the conference call.
5.
Press
/BACK on any handset to end a three-party conference call and leave the
other handset engaged with the caller.
NOTE
During an external call, pressing
the call and set up a conference call.
3.15
Setting the dial mode
The default dialing mode is suitable for your country and network operator. It is unlikely that
you should need to change this setting unless advised to do so.
1.
Press MENU and then VOL+ or REDIAL/VOL- to select
2.
Press MENU to select
3.
Press MENU and then VOL+ or REDIAL/VOL- to select
4.
Press MENU to save.
NOTE
If the pulse mode is selected, press TONE/* to switch from pulse to tone dialing temporarily
when dialing out. After the call is ended, the dial mode will change back to pulse.
3.16
Setting the flash time
The default flash time is 600MS. It is unlikely that you should need to change this setting unless
advised to do so.
1.
Press MENU and then VOL+ or REDIAL/VOL- to select
2.
Press MENU and then VOL+ or REDIAL/VOL- to select
3.
Press MENU and then VOL+ or REDIAL/VOL- to the flash time you want.
(8 options are available : 90, 100, 110, 250, 300, 400,
4.
Press MENU to save.
3.17
Setting the area code
1.
Press MENU and then VOL+ or REDIAL/VOL- to select
2.
Press MENU and then VOL+ or REDIAL/VOL- to select
3.
Press MENU and then enter the area code.
4.
Press MENU to save.
20
/FLASH or
DIAL
MODE.
/SPEAKER on any handset will join in
SETUP
BS.
TONE
or PULSE.
SETUP
BS.
FLASH
TIME.
600
and 700MS)
SETUP
BS.
AREA
CODE.
Using the Phone