Table of Contents
Advertisement
Poor audio quality
•
If the base is too close to electrical appliances,
reinforced concrete walls, or metal door frames,
move the base from these areas.
No ring tone
•
The ringer may be off.
•
The volume may need to be increased.
Caller ID does not work
•
Check your subscription with your network
operator.
•
If you subscribe to high-speed internet service
(Digital Subscriber Line - DSL) through your
telephone lines, you must install a DSL filter
between the telephone base and the telephone
wall jack. The filter will prevent noise and caller
ID problems caused by DSL interference. Please
contact your DSL service provider for more
information about DSL filters. A phonebook entry
cannot be stored.
36
•
The phonebook is full. Delete an entry to free
memory.
No display
•
Try recharging or replacing the rechargeable
battery pack.
•
Reset the base. Unplug the unit's electrical, then
plug it back in.
•
If the LED is not lit up, then try to unplug the unit's
electrical power, and then plug it back in.
If the handset disconnects from the base during a
phone call
•
Check that the power cord is connected properly
into the base.
•
Check that the power adapter is connected
properly into the electrical outlet.
•
Move the handset closer to the base. It may be out
of range.
Help
Advertisement
Table of Contents
