Headlight Adjustment - Polaris Offroad Vehicle Owner's Manual

Headlight Adjustment

10. Carefully unplug the socket from the lamp. Remove the panel and set it aside.
11. Replace the oil reservoir cap.
12. Stand the panel containing the headlight assembly on end to allow access to
the back of the headlight assembly.
13. Disengage the wire bail holding the headlight lamp in place and move it out of
the way.
14. Grasp the base of the lamp and lift it out.
15. Reverse the previous steps to replace the lamp and reassemble the panels.
High Beam Headlight Adjustment
The headlight beam can be adjusted to any position desired by turning the four
screws at the outer corners of the lamp housing.
1. Place the vehicle on a level surface with the headlight approximately 25' (7.6
m) from a wall.
2. Measure the distance from the floor to the center of the headlight and make a
mark on the wall at the same height.
3. Start the engine and turn the headlight switch to high beam.
4. Observe headlight aim. The most intense part of the headlight beam should
be aimed 2" (5.1 cm) below the mark placed on the wall in step 2. NOTE: Rider
weight must be included on the seat. For machines with separate low beam
lights, the drop on low beam should be 8" (20.3 cm) in 25'.
5. Adjust beam to desired position by turning screws on the housing.
MAINTENANCE
126