Polaris Offroad Vehicle Owner's Manual page 56

CONTROL AND PARTS FUNCTIONS
Engine Cooling System
Radiator Coolant Level Inspection
NOTE: This procedure is only re-
quired if the cooling system has been
drained for maintenance and/or re-
pair. However, if the recovery bottle
has run dry, the level in the radiator
should be inspected and coolant
added if necessary.
WARNING Never remove the
pressure cap when the engine is
warm or hot. Escaping steam can
cause severe burns. The engine
must be cool before removing the
pressure cap.
To access the radiator pressure cap:
Gen II - To access the pressure cap,
remove the access cover on the front
of the ATV just below the oil cap. Us-
ing a flat, stubby screwdriver loosen
the screw 1/4 turn and pull the cover
forward and up to remove.
Gen III - To access the pressure cap,
clean the area around the oil cap and
remove the oil cap (2 cycle models).
Remove front cover by placing your
fingers under the front of the cover
and pulling upward. Reinstall oil cap.
Gen IV - Remove the four screw se-
curing front rack. Remove front cov-
er by placing your fingers under the
front of the cover and pulling upward.
NOTE: Use of a non-standard pres-
sure cap will not allow the recovery
system to function properly. If the
cap should need replacement con-
tact your dealer for the correct re-
placement part.
Gen II
Pressure Cap
Gen III
Pressure Cap
Gen IV
Front
Cover
Rack
46