Polaris Offroad Vehicle Owner's Manual page 49

CONTROL AND PARTS FUNCTIONS
Throttle Control/Brakes
Throttle Control Lever Stop
The throttle control lever incorporates
an adjustable stop. This can be ad-
justed to limit the amount of throttle
opening by loosening the screw (A) and
sliding the stop to a desired setting.
Then tighten screw.
Front and Rear Brakes
The brake fluid in the master cylinder,
which is located on the left handlebar,
should be checked before each ride.
The fluid level can be seen through the
plastic reservoir, and should be main-
tained between the indicated max and
min marks on the reservoir. NOTE:
When checking the fluid level, the ATV
must be on level ground the the handle-
bars straight. If the fluid level is low add
DOT 3 (PN 2870990) only.
WARNING: Once a bottle of brake fluid is opened, use what is necessary and dis-
card the rest. Do not store or use a partial bottle of brake fluid. Brake fluid is hygro-
scopic, meaning it rapidly absorbs moisture from the air. This causes the boiling
temperature of the brake fluid to drop, which can lead to early brake fade and the
possibility of serious injury.
The front and rear brakes are applied by squeezing the left side brake lever toward
the handlebar. The front and rear brakes are hydraulically activated disc type
brakes which are activated by one lever only.
Always test brake lever travel and reservoir fluid level before riding. When
squeezed, the lever should feel firm. Any sponginess would indicate a possible
fluid leak or low master cylinder fluid level which must be corrected before riding.
Contact your dealer for proper diagnosis and repairs.
WARNING
Improperly operating the ATV with a spongy brake lever can result in loss
of braking. Loss of braking could cause an accident.
Never operate the ATV with a spongy feeling brake lever.
39
A
Bottom View
Master Cylinder
Max
Reservoir
Min