Troubleshooting - Samsung SCS-26UC2 User Manual

TROUBLESHOOTING

In the unlikely event that you have problems, check the following:
Trouble
The PWR LED is not lit
The SYS LED lights up red
The WAN LED lights up red
26
_ © SAMSUNG Electronics Co., Ltd.
Solution
- Make sure that one end of the power cord is securely
connected to an active outlet and that the other end is
properly connected to the power supply.
- Make sure the power supply connector is securely inserted
into the rear PWR connector on the back of the UbiCell
Plus.
The UbiCell Plus was unable to register.
A red System LED indicates a system error was detected.
Contact Samsung Customer Service.
- A red light indicates that the WAN port is receiving power
but has not detected a valid Ethernet connection.
- Confirm that both ends of the Ethernet cable are securely
plugged into the WAN port on the UbiCell Plus and into an
open port on the router(or modem).