Operation Check - Furuno NXT-600 Operator's Manual

3. INITIAL SETTINGS
#2
OFF
ON
After setting up the transducer at the DFF1-UHD, set the transducer type at the NavNet device.
See respective Installation Manual for the procedure.
Note: DIP Switch S3 is for factory use. Do not change the settings.
3.2

Operation Check

For NavNet TZtouch, the DFF1-UHD is powered on/off from the ship's switchboard. For NavNet
3D, it is powered on/off from the display unit. The LED on the cover of the DFF1-UHD lights or
blinks according to equipment state, as described in the table below.
LED state
Lit continuously
Blinking every two seconds
Blinking every 0.4 seconds
Host name
ES092002
ES092003
LED state and meaning
• Standby state. (If no signal is received via LAN for more than 10
minutes, the equipment automatically goes into standby to lessen
power consumption.)
• Power on (20 seconds during initialization)
• IP address not set
Normal operation
Transducer settings at NavNet device not properly set.
LED
14
IP address
172.031.092.002
172.031.092.003
Meaning