Linkcom Link Gate SIP User Manual page 8

6.2 Incoming calls trunk route configuration in P2P mode

When the Link gate SIP should be set to P2P mode, it is important to set the translation table for incoming phone

calls to match phone subscriber extension's numbers with IP addresses.

After making changes use the save changes button.

6.3. Outgoing call configuration:

By default there is no call restriction programmed in the (LCR) table. The Link Gate SIP accepts all SIP calls through

its trunk interfaces « IP 1adress » and « IP 2adress ». Calls will be rooted sequentially over modules GSM 1 et 2.

Set up IPBX External call trunk route parameters (trunk SIP or Outbound proxy sip), SIP phone or soft phone to

make calls through the Link Gate SIP. The only parameters that should be configured are IP 1 and 2 addresses and

port SIP, 5060 (there is no SIP authentification in mode P2P).

7. SIP Server mode Configuration

To parameter the Link gate SIP in SIP server mode, refer to paragraph 2: "Setting operational mode"

In SIP Server mode « Number translation » menu is not used

Two new menus are available: « SIP Parameters » and « SIP Server »

In SIP mode Server the Link Gate SIP can be parameter in 2 ways:

SIP server (internal) : The Link Gate SIP work in this case in stand alone it allow recording up to 10 SIP

•

phone. The Link Gate SIP in this case behaves as an IPBX.

SIP server (external) : The Link Gate SIP is connected and registered to an IPBX as a SIP phone. For each

•

GSM Module one SIP account should be created on the IPBX to allow receiving external calls. Outgoing calls

through the GSM channels are made by adding 2 trunks SIP through IP 1 and IP 2 of the Link Gate SIP.

7.1. SIP server mode (internal)

Set the Link Gate SIP in MENU SIP SERVER tick the Blanc Box to Enable SIP server mode

Give then the Name of the SIP server« realm »

Enter the outgoing call prefix to access individually each channel.

You are able then to register up to 10 SIP accounts for your SIP phone.

Complete the number of each SIP phone extension ( this number will same as user SIP name in Password).

After making changes use button save and restart.

Linkcom France

11 rue du Soleil Levant 92140 CLAMART

Set a number and IP

adress, whitch is set

on a desired phone.